Connection Setup
Configure the serial connection between your Flipper Zero and GhostESP device
On this page
Hardware Connection
Connect your ESP32 device to your Flipper Zero via UART:
| ESP32 Pin | Flipper GPIO Pin |
|---|---|
| TX | GPIO 13 or 15 |
| RX | GPIO 14 or 16 |
| GND | GND |
| VCC | 3.3V (if needed, check your board’s power requirements) |
Note: Pin configurations may vary depending on your Flipper Zero setup. Refer to your specific hardware documentation or the companion app’s connection guide.
Software Connection
- Power on your GhostESP device
- Launch the GhostESP app on your Flipper Zero
- The app will automatically attempt to connect via serial
If the app can’t connect or the connection drops during use, see Troubleshooting for the full checklist.
Related Tasks
Once connected, explore the available features: