Title: Connection Setup
Description: Configure the serial connection between your Flipper Zero and GhostESP device
URL: /latest/flipper-app/connection/
Version: latest
Section: Flipper Zero App
Keywords: connection, uart, serial, gpio, wiring
Search index: /search-index.json

# Connection Setup

> Configure the serial connection between your Flipper Zero and GhostESP device

## On this page

- [Hardware Connection](#hardware-connection)
- [Software Connection](#software-connection)
- [Related Tasks](#related-tasks)

---

## Hardware Connection
Connect your ESP32 device to your Flipper Zero via UART:
ESP32 Pin |
Flipper GPIO Pin |
TX |
GPIO 13 or 15 |
RX |
GPIO 14 or 16 |
GND |
GND |
VCC |
3.3V (if needed, check your board’s power requirements) |
Note: Pin configurations may vary depending on your Flipper Zero setup. Refer to your specific hardware documentation or the companion app’s connection guide.
## Software Connection
- Power on your GhostESP device
- Launch the GhostESP app on your Flipper Zero
- The app will automatically attempt to connect via serial
If the app can’t connect or the connection drops during use, see [Troubleshooting](/latest/flipper-app/troubleshooting/) for the full checklist.
## Related Tasks
Once connected, explore the available features:
- [Wi-Fi Features](/latest/flipper-app/wifi-features/)
- [BLE Features](/latest/flipper-app/ble-features/)
- [GPS Features](/latest/flipper-app/gps-features/)