Title: Setup and Remote Mode
Description: Configure NRF24 hardware pins and GhostLink remote analyzer control
URL: /latest/nrf24/setup-and-remote/
Version: latest
Section: NRF24
Search index: /search-index.json

# Setup and Remote Mode

> Configure NRF24 hardware pins and GhostLink remote analyzer control

## On this page

- [Local NRF24 Setup](#local-nrf24-setup)
- [GhostLink Remote Mode](#ghostlink-remote-mode)
- [Troubleshooting](#troubleshooting)

---

Configure the NRF24 analyzer locally on a board wired to an NRF24L01 module, or set up a display/controller build that drives a peer’s analyzer over GhostLink.
## Local NRF24 Setup
Enable the analyzer in project config:
- CONFIG_HAS_NRF24 (shipped builds: Banshee S3 only)
- CONFIG_NRF24_SPI_HOST (2 or 3)
- CONFIG_NRF24_SPI_MOSI_PIN
- CONFIG_NRF24_SPI_MISO_PIN
- CONFIG_NRF24_SPI_SCK_PIN
- CONFIG_NRF24_CSN_PIN
- CONFIG_NRF24_CE_PIN
- CONFIG_NRF24_SPI_CLOCK_HZ
Analyzer behavior tuning:
- CONFIG_NRF24_ANALYZER_SAMPLES_PER_CHANNEL
- CONFIG_NRF24_ANALYZER_SETTLE_US
- CONFIG_NRF24_ANALYZER_CHANNELS_PER_TICK
Pin defaults depend on your selected board config. In menuconfig, these options are under Ghost ESP Options → Misc Options → NRF24 Options.
## GhostLink Remote Mode
Remote mode is for display/controller builds that do not have local NRF24 hardware.
- Enable CONFIG_HAS_NRF24_REMOTE on the controller/display build (shipped builds: Banshee C5 only).
- Pair to a peer device that is built with CONFIG_HAS_NRF24 and physically connected to an NRF24 module.
- Start the analyzer from the controller UI; commands are forwarded over GhostLink.
For pairing and transport setup, see [Dual Communication (GhostLink)](/latest/getting-started/dual-communication/).
## Troubleshooting
- NRF24 analyzer failed to start: check wiring, power, and SPI pin mapping.
- built without CONFIG_HAS_NRF24: rebuild firmware with local NRF24 support.
- No remote stream updates: verify GhostLink connection and that the peer analyzer actually started.