Title: LoRa (Meshtastic & MeshCore) Description: Turn GhostESP into a LoRa mesh node and talk to Meshtastic or MeshCore URL: /v2.2/lora/ Version: v2.2 Section: GhostESP: Revival Keywords: LoRa, Meshtastic, MeshCore, SX1262, Heltec V3, mesh Search index: /search-index.json # LoRa (Meshtastic & MeshCore) > Turn GhostESP into a LoRa mesh node and talk to Meshtastic or MeshCore ## On this page - [Where to Go Next](#where-to-go-next) - [How You’ll Use It](#how-youll-use-it) - [On the Device](#on-the-device) - [Keep It Running](#keep-it-running) --- GhostESP turns an SX1262 radio into a mesh node. Only one of two protocols runs at a time: Protocol | Talks to | Commands | Meshtastic (default) | stock Meshtastic nodes and the official phone app | lora | MeshCore | MeshCore nodes and its companion app | meshcore | Interop is the point: GhostESP uses the same sync word, channels and wire encryption as Meshtastic firmware, so it joins an existing mesh without anything being reflashed. ## Where to Go Next - [First run](/v2.2/lora/getting-started/): set a region, start the radio, send your first message - [MeshCore mode](/v2.2/lora/meshcore/): use MeshCore instead of Meshtastic - [Command reference](/v2.2/lora/commands/): every lora, mesh and meshcore command - [Phone app](/v2.2/lora/ble-app/): pair the official Meshtastic app - [Hardware](/v2.2/lora/hardware/): supported boards and wiring ## How You’ll Use It Where | What you do | On the device | Read and write messages, start/stop the radio, change settings | Phone app | The usual Meshtastic/MeshCore app experience over BLE | CLI or WebUI | First-time setup, boot auto-start, diagnostics, scripting | ## On the Device Open LoRa from the main menu. It opens on a status screen without starting the radio; the first row starts the selected protocol when the radio is off. Action | Touch | Encoder / buttons | Select a row | Tap | Press | Move | Drag | Turn | Back | Back row | Esc or left | - Conversations are grouped per channel and per contact, so channels stay separate. - Outgoing messages show Sending, Delivered, Sent or Failed. Tap a failed one to reopen it in the composer and retry. - Encoder boards: double-press on the status screen toggles the radio. - Heltec OLED: press PRG to cycle pages. On the LoRa page a double-press toggles the radio, and with the radio off the page shows PRESS 2X TO START. ## Keep It Running Auto-start is opt in. The protocol is remembered, so you set it once: lora autostart meshtastic # or: lora autostart meshcore The radio starts a few seconds after the interface, once boot has finished. Meshtastic needs a saved region before it can transmit; MeshCore does not.